Uvp BioLite Xe Instrukcja Użytkownika

BioLite™ Xe MultiSpectral Light Source Installation and User Instructions UVP, LLC Ultra-Violet Products Ltd. 2066 W. 11th Street Unit

BioLite Xe MultiSpectral Light Source 10 2. The lamp assembly will have a wire coming from each end of the xenon bulb. One wire has a male connec

BioLite Xe MultiSpectral Light Source 11 Using the Light Source 1. Set the power switch on the front of the system to the ON (I) position. 2.

BioLite Xe MultiSpectral Light Source 12 a. Fiber Optic Lighting: Press this button to select either Epi or Transillumination lighting. Note tha

BioLite Xe MultiSpectral Light Source 13 Service Procedures Bulb Replacement The BioLite Xe xenon light bulb is a lamp assembly which includes a m

BioLite Xe MultiSpectral Light Source 14 5. Plug the power cable into the receptacle on the back of the BioLite Xe and the other end into a power

BioLite Xe MultiSpectral Light Source 15 Technical Support UVP offers free lifetime technical support on all of its products and software. Should y

BioLite Xe MultiSpectral Light Source 2 Table of Contents Introduction ...

BioLite Xe MultiSpectral Light Source 3 Introduction The BioLite Xe MultiSpectral Light Source is a 150 watt xenon light source designed for use w

BioLite Xe MultiSpectral Light Source 4 System Components Refer to the packing slip and schematic shown below for specific parts and components in

BioLite Xe MultiSpectral Light Source 5 Output Spectrum The graph below displays the spectral emission curve for the xenon arc light source within

BioLite Xe MultiSpectral Light Source 6 Setup Instructions BioLite MultiSpectral Light Source Setup 1. Plug the power cord into the receptacle o

BioLite Xe MultiSpectral Light Source 7 Epi Light Guide Installation (BioSpectrum®) 1. Remove the epi light covers at the top of the darkroom.

BioLite Xe MultiSpectral Light Source 8 Epi Light Guide Installation (GelDoc-It®2/TS2 and ChemiDoc-It®2/TS2) 1. Remove one stopper at the left s

BioLite Xe MultiSpectral Light Source 9 7. Remove the rubber cap from the input side of the fiber optic trunk and plug the cable into the left por